Guitar / Bass

Bass Guitar

Get Adobe Reader Spec Sheet

WHEEL HOUSE 200

The warmth of hemp meets the power and responsiveness of neo in this versatile 15 inch speaker. Touch-sensitive and balanced, the Wheelhouse delivers warm, smooth tone throughout the entire spectrum, allowing you to utilize your amp controls to shape your sound. It handles pedals and amp EQ with ease. Go from country to fusion to blues and make it sound like it?s right in your wheelhouse.

Suggested Retail  $234.99
Your Price  $194.99

For contiguous USA shipments only.

  • Free Tech Support
  • 7-Year Warranty*
*Warranty policy may vary outside the USA.
This table charts the specifications for the WHEEL HOUSE 200 speaker
Speaker Detail
Specification
Nominal Basket Diameter15", 381 mm
Nominal Impedance*8 Ω
Power Rating*
Program PowerN/A
Watts200 W
Resonance51 Hz
Usable Frequency Range60 Hz - 3.5 kHz
Sensitivity*101.5 dB
Magnet Weight11 oz.
Gap Height0.375", 9.5 mm
Voice Coil Diameter2.5", 64 mm
Thiele & Small Parameters
Resonant Frequency (fs)51 Hz
DC Resistance (Re)7.49 Ω
Coil Inductance (Le)0.46m H
Mechanical Q (Qms)16.85
Electromagnetic Q (Qes)0.46
Total Q (Qts)0.45
Compliance Equivalent Volume (Vas)182.73 liters / 6.45 cu.ft.
Peak Diaphragm Displacement Volume (Vd)175.8 cc
Mechanical Compliance of Suspension (Cms)0.21 mm/N
BL Product (BL)15.58 T-M
Diaphragm Mass Inc. Airload (MMs)47 grams
Efficiency Bandwidth Product (EBP)111
Maximum Linear Excursion (Xmax)2.22 mm
Surface Area of Cone (Sd)791.7 cm2
Maximum Mechanical Limit (Xlim)0 mm
Mounting Information
Recommended Enclosure Volume
Sealed N/a
Vented N/a
Driver Volume Displaced0.128 cu.ft. / 3.62 liters
Overall Diameter15.16", 385.1 mm
Baffle Hole Diameter13.87", 352.3 mm
Front Sealing GasketYes
Rear Sealing GasketN/A
Mounting Holes Diameter0.25", 6.4mm
Mounting Holes B.C.D.14.56", 369.8mm
Depth5.63", 142.9 mm
Net Weight8.2 lbs, 3.72 kg
Shipping Weight10.4 lbs, 4.72 kgs
Materials of Construction
Coil ConstructionEdge Wound Aluminum
Coil FormerPolyimide former
Magnet CompositionNeodymium Magnet
Core DetailsVented core
  
Basket MaterialsPressed steel basket
Cone Composition
Cone Edge CompositionFull molded paper
Dust Cap CompositionTreated paper
Hide
Footnotes

Multiple units exceed published ratings evaluated under EIA 426A specification while tested in a free-air, non-temperature-controlled environment. Multiple compression drivers exceeded published ratings evaluated under EIA-426A or AES specification while mounted on Eminence’s H290, H290S, or H2EA horn in a non-temperature-controlled environment.

The average output across the usable frequency range when applying 1W/1m into the nominal impedance. i.e: 2.83V/8Ω, 4V/16Ω. Eminence response curves are measured under the following conditions: All speakers are tested at 1W/1m using a variety of test set-ups for the appropriate impedance | LMS using 0.25" supplied microphone (software calibrated) mounted 1m from wall/baffle | 2 ft. x 2 ft. baffle is built into the wall with the speaker mounted flush against a steel ring for minimum diffraction | Yamaha P3500S amplifier | 2700 cu. ft. chamber with fiberglass on all six surfaces (three with custom-made wedges). Compression drivers were tested using a 2ft x 2ft baffle built into the wall with horn front mounted.

BETA 8CX, 10CX and 12CX are coaxial speakers with tweeter sold separately. The data for these coaxial woofers was calculated with the ASD:1001 driver screwed into the woofer, but not active.

Prices, specifications and product cosmetics are subject to change without notice.